一本加勒比hezyo无码专区,国产在视频线精品视频,av无码不卡一区二区三区,亚洲乱码国产乱码精华

Through calculation and analysis, the reason is that the piston rod bending: boom cylinder with both ends of the rack and the movable arm is connected with a tilt phenomenon, bearing width is too small, or improper assembly instructions to adjust the clearance between the side wear,

The daily operation of the loader needs oil lubrication, so how to install the loader to prevent oil pollution, and now we have to know how to install the loader to prevent oil pollution:

The lifting mechanism is composed of an electric motor, a speed reducer, a lifting chain and a winding drum.

Loader is mainly used to shovel soil, sand, lime, coal and other bulk materials, but also for the ore, hard soil, such as mild shovel digging operations. The following is to introduce the loading arm can not lift the reasons.

The cavitation damage of the cylinder block and cylinder liner of the loader causes cracks and even through holes, which results in the cooling water entering into the cylinder and the oil. The main cause of cavitation is the vibration of cylinder liner.

1, the use of vehicles in winter is relatively difficult, it is recommended not to start the vehicle every 8 seconds. The interval should be one minute.

It is certainly a fuel consumption than single cylinder double cylinder low, choose loader should take into account the economic structure, durable vehicle, choose loader is simple to make a few suggestions.

Loader solution first check the pressure of the variable table, whether there is a blocking position in the buck phenomenon. If the pressure is less than 98.1KPa, a drive must be powerless.